Product Search
Product Search

Secure Checkout
DIRTY AIR 2024 Handlebar Grip Switch with Push Buttons Overlay
    DIRTY AIR 2024 Handlebar Grip Switch with Push Buttons Overlay
    Purchase DIRTY AIR 2024 Handlebar Grip Switch with Push Buttons Overlay
    • SKU: DA-GS02
      DIRTY AIR 2024 Handlebar Grip Switch with Push Buttons Overlay

    • $99.99

    •  

    Please read all notes below:

    FOR NEW STYLE H-D TOURING HAND CONTROLS

    FITS 2024-NEWER TOURING MODELS & 2023.5 CVO

    OVERLAYS FACTORY HAND CONTROL HOUSING CLAMP

    WILL NOT FIT 2023-OLDER MODELS, WILL NOT FIT ROAD KING MODELS OR TRIKE MODELS

    DIRTY AIR Handlebar Grip Switch, works with pretty much any air ride system that uses electric switch(es).  New 6061 billet aluminum housing with waterproof push buttons, select finish options.  Fits left or right side.  Each push button can control either the UP or the DOWN function for your air system.  A rear system would need one unit, a front+rear system would require (2) complete handlebar grip switch units, one to mount on the left and one to mount on the right.  To use our handlebar switch unit to control an MRI electric center stand, a special relay system must be added to allow the grip switch to reverse polarity to the center stand to control UP and DOWN functions on the center stand.  This switch housing overlays the oem housing clamp used to secure the clutch assembly on the left side or master cylinder on the right side and includes longer bolts to install.  Switch unit is hardwired with 69" wire leads and has 3 wires - 12v+ power, up and down.

    *Fits 2023.5-newer Harley-Davidson hand controls.  Fits any diameter handlebar, as long as you are using Harley-Davidson hand controls, and not an aftermarket clutch/master cylinder assembly*

    *Works with DIRTY AIR systems.  If using on other systems or for other components, please note the push buttons maximum current allowance is 1 amp.  Any component drawing over 1 amp requires a relay*

    *Handlebar switch power wire should be connected to a fused circuit on the bike that is on only when the bike is on.  If you choose to conenct to constant 12v+ power, a 5A fuse should be added to the blue power wire*

    *These handlebar switch housings have multiple notches for wires to exit.  Wires must be ran externally, makes sure wires are not pinched under housing when installing*